Rc Hobbies

Turnigy dlux esc 160a manual

HV esc 160a turnigy dlux User manual

Programming Controller
Before you start do the setup of this esc the previous controller must be connected to the appropriate motor so that you can hear a variety of tones and sounds that will confirm the action.

REMOVE the propeller on the motor
when the controller is being programmed. Overview:
1 Move the transmitter stick position to full throttle while powering "on" the controller initiates
programming sequence.
2 If within 1-5 seconds of power-ups, you move the throttle stick to the off position you will be reprogrammed brake on / off.
3 5 + seconds after power-up, the programming sequence for Battery Type, Rotation, Acceleration, Under
Voltage, Time, Switching Frequency, Revert to Default Factory, and Active RPM Control starts.
4 You can only change one setting time; if you need to change more settings, disconnect the motor
battery and wait for 5 seconds. Repeat the procedure for changing the settings next.
5 5 second + programming always starts at the "Battery Type" and go one by one until you
reach the last option "Active RPM Control". It is not possible to "skip ahead" or retreat.
6 When you hear beeps corresponding to the parameter you want to change, move the throttle stick
down, then you will hear two confirmation tone. The setting is now changed and memorized.
7 You can exit the programming mode at any time if you remove the battery from the ESC connector.

Method Enter Programming Mode
1.Switch ON the transmitter, and move the throttle stick to full position throttle.
2.Connect the motor battery and turn ON the receiver (BEC) switch.
3.Listen to the tone sequence parameters you want to change; when you reach the parameter you
want to change, move the transmitter throttle stick to the bottom position.

Note:
Start "2 Battery Type" and continuing through "9 Active RPM Control", each pattern plays a row for a total of three plays each. Also note, that the user is trying to show a pattern as Turnigy "musical notes". sometimes found that some of the correlation between music notation Turnigy is not true, so that not try to reproduce it here. It is actually best to keep pace with the number of events grouped together and separated by commas that appear after the number 3, rather than trying to interpret musical notation.

Prepare Brake propeller or disable
Follow the above procedure to enter the programming mode. If you move the throttle stick to off within 5 seconds, Brake setting will change. (ON ~ OFF, or OFF ~ ON). for more information you can download turnigy dlux 160a hv manual from this site