Rc Hobbies

Turnigy 9XR Saving And Editing Manual

Actually, this way I quote from the manual of  Turnigy 9XR is intended to facilitate the setting is a radio transmitter. so if you're wondering how to do the settings for Turnigy 9XR in this case to edit and save this is how. As a rule once a value is changed it is saved. You can turn off your Tx and turn it back on and the values will be saved. The values are saved internally in the MCU's eeprom. However there is a slight delay sometimes so it's probably a good idea to wait a couple of seconds before turning off.

There is no undo functionality. Once something is erased/changed it's changed for good. Generally, when a value is highlighted and you cannot move left or right then pressing [UP]/[DOWN] will change that value. When moving left or right is possible you need to press [MENU] to edit that value. Edit-mode is displayed by the cursor blinking. To exit edit-mode press either [MENU] or [EXIT]. Also, it is possible to change values with the P3 pot (the one at the front of the Tx called PIT. TRIM/AUX 2).


On Startup- Quick Model Select
On startup holding a certain key will load an associated model memory. This is useful for quickly
changing between model memories:
• Holding [MENU] Will load Model memory #1
• Holding [EXIT] Will load Model memory #2
• Holding [DOWN] Will load Model memory #3
• Holding [UP] Will load Model memory #4
• Holding [RIGHT] Will load Model memory #5
• Holding [LEFT] Will load Model memory #6
Hopefully can help.